Owner`s manual

OM-172 324 Page 40
7-5. Changing To Adaptive Pulse Welding
Welding parameters are the same
for both a Pulse and an Adaptive
Pulse welding program. While
welding adaptively, the unit uses
feedback to attempt to maintain a
constant arc length. To change to
Adaptive Pulse welding, proceed
as shown:
1 Pulse Panel Display
Default display when unit is first
turned On, at other times use mode
select button to select Process.
1
Mode Select
>P r o c e s s
Ca r d
Sequence
>P r g 1
Pu l se
035” Steel
Argon– Oxy
Parameter
Select
>P r o c e s s
Ca r d
Sequence
Prg 1
>P u l s e
035” Steel
Argon– Oxy
Increase/
Decrease
>P r o c e s s
Ca r d
Sequence
Prg 1
>A d a p tPu lse
035” Steel
Argon– Oxy