Owner`s manual

OM-172 324 Page 37
7-3. Selecting Teach Point Wire Feed Speed
1 Process Display
When unit is first turned On, Pro-
cess is the default screen, at other
times use mode select button to se-
lect Process.
2 Teach Display
Use parameter select button to se-
lect Teach.
Use increase/decrease buttons to
select On.
3 IPM (Teach Point)
The parameters associated with
this wire feed speed teach point can
be modified. The wire feed speed
value itself cannot be changed from
this unit.
To set or adjust teach point parame-
ters, go to Section 7-4.
3
Mode
Parameter
Increase/
Decrease
Parameter
Select
1
>P r o c e s s
Ca r d
Sequence
>P r g 1
Pu l se
035” Steel
Argon-Oxy
Pu l se
035” Steel
>T e a c h O f f
Teach On
>4 0 0 IPM
340 Apk
70 Abk
>T e a c h O n
400 IPM
340 Apk
70 Abk
2
Select
Select