Owner`s manual

OM-172 324 Page 34
6-4. Setting Crater Sequence Display
1 Crater Parameters Display
Parameter ranges are as follows:
Seconds, 0-2.50 Sec. If value set is
zero (0), there is no Crater
sequence.
Trim (Arc Length), 0-99
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Section 6-5.
1
>C r a t e r
0.00 Sec
50 Tr im
200 IPM
Crater
0.20 Sec
>5 0 Tr im
200 IPM
Set Desired
Increase/
Decrease
Parameter
Select
Set Desired
Increase/
Decrease
Set Desired
Increase/
Decrease
Parameter
Select
Proceed to next figure.
Increase
Trim
Parameter
Select
Time
Parameter
Select
Crater
0.20 Sec
60 Tr im
>1 5 0 IPM
Crater
>0 . 0 0 Sec
50 Tr im
200 IPM
>C r a t e r
0.20 Sec
60 Tr im
150 IPM
Wire Feed Speed
6-5. Setting Postflow Sequence Display
1 Postflow Parameters Display
Postflow can be adjusted from
0-9.9 seconds. If value set is zero
(0), there is no Postflow sequence.
1
Parameter
Select
Set Desired Time
Increase/
Decrease
Proceed to next figure.
Increase
>P o s t f l o w
0.0 Sec
Pos t f l ow
>0 . 0 Sec
>P o s t f l o w
1.2 Sec
Parameter
Select