Owner`s manual

OM-172 324 Page 33
6-2. Setting Preflow Sequence Display
1 Mode Select Button
When unit is turned On, Process is
the default mode, at other times,
use mode select button to select
Sequence.
2 Parameter Select Button
Use parameter select button to se-
lect parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Section 6-3.
3
Set Desired Time
Increase/
Decrease Proceed to next figure.
>P r e f l o w
0.0 Sec
Pref low
>0 . 0 Sec
>P r e f l o w
1.2 Sec
Increase
Parameter
Select
Parameter
Select
Parameter
Select
2
Process
Ca r d
>Sequence
>P r e f l o w
0.0 Sec
Mode Select
1
6-3. Setting Weld Sequence Display
1 Weld Parameters Display
Parameter ranges are as follows:
Trim (Arc Length), 0-99
Wire Feed Speed, 50-780 Inches
Per Minute, IPM
Go to Section 6-4.
Parameter
Select
We l d
60 Tr im
>200 IPM
Set Desired Weld Sequence
Increase/
Decrease
We l d
60 Tr im
300 IPM
Proceed to next figure.
Increase
1
We l d
>5 0 T r i m
200 IPM
Increase/
Decrease
Set Desired Weld
Parameter
Select
Sequence Trim
Wire Feed Speed