Owner`s manual

OM-172 324 Page 19
4-10. Setting Switches On Maxtron 450 Ampere Inverter Model Welding Power Source
Ref. ST-150 171-C / Ref. SC-154 197
 Set switches as shown for all welding processes
when using this interface unit.
SECTION 5 – INTRODUCTION TO PROGRAMMING
5-1. Interface Unit
ST-801 077-A
1 Interface Unit
The interface unit is designed for
use in pulse MIG welding (adaptive
or standard), or MIG welding.
The unit is factory-equipped with
eight programs for pulse MIG weld-
ing (see Section 5-2). The pro-
grams contain parameters that
maximize welding performance for
each combination of wire and
shielding gas.
The unit also provides memory for
the creation of up to eight MIG pro-
grams (see Section 8).
The weld programs require the user
to enter information specific to the
welding application. This informa-
tion is entered as a part of program
development (see Section 6 for
pulsed MIG information), and dur-
ing setup (see Section 10).
1