Owner`s manual

OM-2226 Page 59
CE Models Only
2
SEL
- - -
2
4
1
And
Rear Panel
3
5
PPP
1 Output Switch Pad
2 Pulser Switch Pad
3 Power Switch
Turn power off. Push and hold the Out-
put and Pulser switch pads and turn On
power switch. Hold switch pads for
approximately 7 seconds (or until soft-
ware version number _ _ _ _ _
_-_clears, and meters display
[SEL] [Ć-- ). Upon power up as described,
the A LED under the right display and
the Pulser On LED illuminate.
4 Encoder Control
5 PPP Meter Display
Turn Encoder to change between stan-
dard and (PPP) meter display.
When the (PPP) meter display feature is
active while pulse welding, the (PPP) will
be displayed on the right meter display,
and the Meter Hold feature is disabled.
The (PPP) meter display feature will not
effect the normal amperage display or
Meter Hold capabilities when in a non-
pulse welding mode.
Press torch trigger or turn off power to
save setting and end this set-up.