Owner`s manual

OM-2226 Page 56
C. Lockout Levels (Continued)
Level 3
+/– 10 % Amperage Adjust Control
Select Stick Or TIG
Level 4
Remote Amperage Control
Level 3
NOTE: Before activating lockout
levels, be sure that all procedures
and parameters are established. Pa-
rameter adjustment is limited while
lockout levels are active.
NOTE: Remote amperage control is
not available in level 3.
Includes all the functions of levels 1
and 2 plus the following:
+/– 10% adjustment of preset TIG
or Stick Weld Amps
Select desired process, TIG or
Stick, and use Encoder control to
adjust amperage +/– 10% of preset
amperage value, up to the limits of
the machine. If operator tries to go
beyond the +/– 10%, the amperage
(right) meter will display [LL3] as a re-
minder.
Pulser ON/Off Control
Gives operator the ability to turn on/
off the Pulser control.
Level 4
NOTE: Before activating lockout
levels, be sure that all procedures
and parameters are established. Pa-
rameter adjustment is limited while
lockout levels are active.
Includes all the functions of levels 1,
2, and 3 plus the following:
Remote Amperage Control
Allows operator to use remote am-
perage control if desired. Remote
control operates from minimum to
maximum of preset amperage val-
ue. Connect remote control device
according to Section 3-6.
Pulser On/Off Control
Turn Pulser Control On/Off
Use Encoder Control To
Adjust Amperage +/– 10%
Of Preset Value.
AJ
B
K
I
C
L
NH
D
M
G
E
F