Owner`s manual

OM-2226 Page 51
4-18. 4T Momentary Operation (DX, LX And All CE Models)
1 4T Momentary Display
Select 4T Momentary according
to Section 4-14.
If unit is equipped with Sequence
Controls, a 4T Momentary trigger
method is available.
4T Momentary torch trigger op-
eration is as shown.
While in 4T Momentary mode,
once the operator toggles out of
weld current and begins final
slope, toggling again will break
the arc and go to postflow.
NOTE: When a remote switch is
connected to the welding power
source, only trigger input is func-
tional. Amperage is controlled by
the welding power source.
Application:
Use 4T Momentary trigger meth-
od when the functions of a remote
current control are desired, but
only a remote on/off control is
available.
Select 4T Momentary trigger
method according to Section
4-14.
=
SEL
H4E
4T Momentary
Current (A)
Preflow
Initial Amps
Initial Slope
Final Slope
Postflow
Push & Release
Trigger In Less
Than 3 Sec.
Push & Release
Trigger In Less
Than 3/4 Sec.
Weld Amps
Final Amps
Push & Release
Trigger In Less
Than 3/4 Sec.
1
Push & Release
Trigger In Less
Than 3/4 Sec.
NOTE: If torch trigger is held more than 3 seconds, operation reverts to Remote Trigger (Standard) mode. If arc is broken
and trigger is depressed, HLP-10 will be displayed (see Section 5-3).