Owner`s manual

OM-2226 Page 50

4-17. Spot Control Operation (All Models)

1 Spot Function Display

Select Spot function according to

Section 4-14.

2 Amperage Switch Pad

3 Encoder Control

Set spot parameters as follows:

Press Amperage switch pad once

(A LED turns on) and turn Encoder

to set spot amperage.

4 Spot Time Display

Press Amperage switch pad again,

(S LED lights) and turn Encoder to

set spot time (.1–25 seconds). Fac-

tory default setting is 1 second.

NOTE: While in Spot Control, Se-

quencer settings will be ignored,

and will not be programmable.

NOTE: While in Spot Control, when

a remote switch is connected to the

welding power source, only trigger

input is functional. Amperage is

controlled by the welding power

source.

Torch trigger operation is as shown.

Application: To provide a timed

weld. Also for tacking, and thin

sheet joining.

SEL SPO

Spot

Current (A)

Preflow

Postflow

Timed Spot Weld Amps

Push & Hold

Trigger

NOTE: If arc is broken and trigger is depressed, or trigger is still depressed after postflow time is complete, HLP-10 will be

displayed (see Section 5-3).

CE Models

Non CE Models

SPO

1.0