Owner`s manual

OM-2226 Page 42
C. Setting Programmable Start Time (All Models)
NOTE: Before accessing programmable
start time mode, be sure that all procedures
and parameters are established. Especial-
ly, check for proper amperage setting (see
Section 4-8). Parameter adjustment is limit-
ed while Programmable Start Time mode is
active.
Welding cycle can be executed while in
programmable start mode, but program pa-
rameters cannot be adjusted while in this
mode.
1 Amperage Switch Pad
2 Encoder Control
To adjust Programmable Start Time pro-
ceed as follows:
Press Amperage switch pad. Switch pad
LED turns on, meter S LED turns on, and
[SEL] [1 ] is displayed on meters.
The [1 ] displayed on the amps meter is the
factory default setting, and can be adjusted
from 1 to 200 milliseconds by turning the
Encoder control.
To save changes, turn power Off.
Non CE Models Only
1
2
SEL
1