Owner`s manual

OM-2226 Page 41
CE Models Only
NOTE: Before accessing programmable
TIG Impulse Start Amperage mode, be
sure that all procedures and parameters
are established. Especially, check for prop-
er amperage setting (see Section 4-8). Pa-
rameter adjustment is limited while pro-
grammable TIG Impulse Start Amperage
mode is active.
Welding cycle can be executed while in
programmable start mode, but program pa-
rameters cannot be adjusted while in this
mode.
1 Amperage Switch Pad
2 Encoder Control
To adjust TIG Impulse Start Amperage pro-
ceed as follows:
Press Amperage switch pad. Switch pad
LED turns on, meter A LED turns on, and
[SEL] [25] is displayed on meters. TIG Im-
pulse LED is on. Note: If a remote mode
and pulser functions are active, their re-
spective LEDs will be illuminated.
The “25 ” displayed on the amps meter is
DC start amps (it is also the factory default
setting), and can be adjusted from 1 to 200
amps by turning the Encoder control.
To change start time, proceed to Section C.
To save changes to TIG Impulse Start Am-
perage without changing start time, turn
power Off.
1
SEL
25
2