Owner`s manual

OM-2226 Page 39
CE Models Only
NOTE: Before accessing programmable
TIG HF Impulse Start Amperage and Time
modes, be sure that all procedures and pa-
rameters are established. Especially,
check for proper amperage setting (see
Section 4-8). Parameter adjustment is limit-
ed while programmable TIG HF Impulse
Start Amperage and Time modes are ac-
tive.
1 Process And Amperage Key Pads
2 Power Switch
To display the programmable TIG HF Im-
pulse Start Amperage and Time screens,
turn Off power. Push and hold Process and
Amperage switch pads and turn On power
switch. Hold switch pads for approximately
7 seconds (or until software version num-
ber _ _ _ _ _ _-_clears meters).
Proceed to Section B and/or C.
Rear Panel
2
1
1
And