Owner`s manual

OM-2226 Page 38
4-13. Programmable TIG HF Impulse Start Amperage And Time Modes
A. Accessing Programmable TIG Start Amperage And Time Modes (All Models)
NOTE: Before accessing programmable
TIG HF Impulse Start Amperage and Time
modes, be sure that all procedures and pa-
rameters are established. Especially, check
for proper amperage setting (see Section
4-8). Parameter adjustment is limited while
programmable TIG HF Impulse Start Am-
perage and Time modes are active.
1 Process And Amperage Key Pads
2 Power Switch
To display the programmable TIG HF Im-
pulse Start Amperage and Time screens,
turn power Off. Push and hold Process and
Amperage switch pads and turn On power
switch. Hold switch pads for approximately
7 seconds (or until software version number
_ _ _ _ _ _-_clears meters).
Proceed to Section B and/or C.
Rear Panel
2
1
1
And
Non CE Models Only