Owner`s manual

OM-2226 Page 30
4-7. Output Control
1
CE Models Only
Current (A)
Preflow
Initial Amps
Initial Slope
Final Slope
Postflow
Weld Amps
Final Amps
Release For
Maintained Switch
Remote (Standard) Torch Trigger Operation
Release Foot Or
Finger Remote
Control
Push & Hold
Foot Or Finger
Remote Control
NOTE: If arc is broken and trigger is depressed, HLP-10 will be displayed (see Section 5-3).
1 Output Control
Press switch pad until desired param-
eter LED is illuminated.
RMT STD (Remote Standard)
Torch trigger operation is as shown.
NOTE: When a foot or finger remote
control is connected to the welding
power source, initial amps, initial
slope, final slope, and final amps are
not functional.
NOTE: If a foot or finger control is con-
nected, initial weld amperage, initial
slope, final amperage, and final slope
is controlled by the remote device, not
by the welding power source.
NOTE: If On/Off only type trigger is
used, it must be a maintained switch.
All functions become active, and must
be set by the operator.
Application: Use Remote Trigger
when the operator desires to use a
foot pedal or finger amperage control.