Owner`s manual

OM-2226 Page 61
SECTION 11 − GUIDELINES FOR TIG WELDING (GTAW)
207 690-A
This symbol indicates which functions should be active for stainless steel.
• Turn power on (switch located on rear panel)
• Press Process switch pad until TIG HF Impulse LED is lit
• Press Output switch pad until RMT STD LED is lit
• Press Adjust switch pad until Post Flow LED is lit
• Turn Encoder control to set 8 seconds of Post Flow time
• Press Amperage A switch pad until LED is lit
• Turn Encoder control to set desired amperage (50 - 80 amps).
. The ammeter displays the parameter for any of the following units of measure when they are active:
amperage, time, percentage, or frequency. The corresponding LED, located directly below the am-
meter, will also light up. The ammeter also displays actual amperage while welding.
Ammeter
11-1. DC - GTAW 16 Gauge Stainless Steel Set-Up
Encoder