Owner`s manual

OM-2226 Page 37
B. Changing Programmable TIG Start Polarity (Dynasty Models Only)
2
SEL
E−
3
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
To adjust TIG Start Polarity proceed as
follows:
Press Amperage switch pad. Switch pad
LED turns on, and meter % LED turns on.
The current Start Polarity, (SEL] [E−] or [SEL]
[EP] is displayed on meters, and can be
adjusted (see Section 5-16) by turning
the Encoder control.
To change Start Amperage, proceed to
Section C.
Or Or
1
C. Changing Programmable TIG Start Amperage (All Models)
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
To adjust TIG Start Amperage proceed
as follows:
Press Amperage switch pad. Switch pad
LED turns on, and meter A LED turns on.
The current Start Amperage is displayed
on the amps meter, and can be adjusted
(see Section 5-16) by turning the
Encoder control.
To change Start Time, proceed to Section
D.
1
2
SEL
20
3
Or Or