Owner`s manual

OM-2226 Page 53
6-8. Setting Unit To Display PPP While Pulse Welding (DX Models Only)
1 Encoder Control
2 PPP Meter Display
Turn Encoder to change between
standard and [PPP] meter
display.
When the [PPP] meter display
feature is active while pulse weld-
ing, the [PPP] will be displayed on
the right meter display, and the
Meter Hold feature is disabled.
The [PPP] meter display feature
will not effect the normal amper-
age display or Meter Hold capabil-
ities when in a non-pulse welding
mode.
2
− − −
PLS
1
PPP
6-9. External Pulse Control
1 Encoder Control
2 Ammeter Parameter Selec-
tion
Turn Encoder to select external
pulse control on or off (off is the
default).
When external pulse control is on:
Remote 14-pin amperage control
of 0 to 10 volts input will be a min-
imum 0 amps to the power
source, a maximum 200 amps
with an external direct amperage
control to power source.
2
oFF
EPc
1