Owner`s manual

OM-2226 Page 51

6-7. Lockout Functions

A. Accessing Lockout Capability

oFF

cod

oFF

Loc

See Section 5 for explanation of controls referred to in all of

Section 6-7.

There are four (1−4) different lockout levels. Each successive level

allows the operator more flexibility.

. Before activating lockout levels, be sure that all procedures and

parameters are established. Parameter adjustment is limited

while lockout levels are active.

To turn On the lockout feature, proceed as follows:

1 Encoder Control

2 Amperage (A) Switch Pad

Press Amperage (A) switch pad to toggle between the lock and code

displays. Toggle switch pad until code is displayed.

Turn Encoder control to select a lockout code number. The code

number will appear on the amp meter. Select any number from [1]

thru [999]. IMPORTANT: remember this code number, as you will

need it to turn the lockout feature off.

Toggle Amperage (A) switch pad until lock is displayed. You may now

select a lockout level.

There are four lockout levels available. Turn Encoder control to se-

lect a lockout level (see Sections 6-7B for lockout level descriptions).

Once the desired three digits have been entered and a lockout level

selected, exit advanced functions mode (see Section 6).

To turn Off the lockout feature, proceed as follows:

Use Encoder control to enter the same code number that was used

to turn on the lockout feature.

Press the Amperage (A) switch pad. The amperage (right) meter dis-

play will change to [OFF]. The lockout feature is now off.

Toggle

Select Code Number

Select Lockout Level

1 to 999

1, 2, 3, or 4

Toggle