Owner`s manual

OM-2226 Page 29
5-2. Encoder Control
1 Encoder Control
Use control in conjunction with ap-
plicable front panel function switch
pad to set values for that function.
1
5-3. Amperage Control
1 A (Amperage Control)
2 Encoder Control
3 Ammeter
See Section 5-13 for Amperage
control range.
Press Amperage switch pad and
turn Encoder control to set weld
amperage. Weld amperage setting
is also peak amperage when Pulser
function is active (see Section 5-9).
2
3
1
5-4. Ammeter And Parameter Display
1 Ammeter
Displays actual amperage while
welding. Meter also displays preset
parameters for any of the following
units of measure when they are ac-
tive: amperage, time, percentage or
frequency. The corresponding
LED, located directly below the am-
meter, will also illuminate.
1