Specifications
listeners' heads is very important, with the cabinet's bottom at least two feet above a seated listener's head. In
fact, if at all possible, the speakers should be located above a standing listener's head, approximately 6 to
7 feet off the floor, so that people walking around the room will be unable to localize them.
c. WALL LOCATION
The surround speakers can be mounted on either the side walls or on the back wall, or even directly in a
corner. They can be flush on the wall, on shelves, on brackets, etc. The Tripole’s
®
great flexibility makes it very
forgiving of room placement that is less than optimum.
The Tripole
®
will give you a combination of an enveloping sound with directionality. You will hear directional
effects, and even imaging when the recording has these qualities. yet at the same time, you will also hear a
diffuse sound from the Dipole drivers mounted on the left and right cabinet baffles.
If the sound lacks the directionality you desire, point the front baffles directly at the main listening position.
Either M&K ST-wall brackets or Omnimount
®
brackets are very useful for this. If the sound is too directional,
angle the speakers towards the back wall or the side wall surface directly behind them. By reflecting sound
behind the listening position, you may increase the sense of envelopment in the sound.
d. USING MULTIPLE PAIRS OF SURROUNDS
Some listeners prefer multiple pairs of surround speakers. In very large rooms, this may even be
necessary. Also, some surround processors and receivers have both side and rear surround channel outputs.
Multiple pairs of surrounds can make a dramatic improvement and provide a deeper and broader surround
effect. When using multiple pairs of surround speakers, a symmetrical installation pattern works best. For
example, one pair could be mounted on the back wall of the room, mounted equidistant from the back corners,
wit the other pair mounted on the side walls of the room, equidistant from the same back corners.
e. USE WITH SURROUND-EX AND OTHER 6.1 CHANNELS SYSTEMS
When using the Tripole
®
surround speaker with a 6.1 channel system, we strongly recommend using two
speakers to reproduce the back surround channel. See Figure 6. These speakers should be mounted on the
TRIPOLE
®
SURROUND SPEAKER
7
FIGURE 6