Owner`s manual

OM-242 880 Page 50
SECTION 9 − PARTS LIST
. A complete Parts List is available on-line at www.MillerWelds.com
9-1. Recommended Spare Parts
Description
Part
No.
Dia.
Mkgs.
Item
No.
Recommended Spare Parts
Quantity
234843 Label, Ice 60t Consumables 1................ .. ..........................................
227877 Filter, Air Element 1................ .. ...................................................
234838 Cable, Work 20 Ft 6 Ga W/Clamp And Male Dinse 1................ .. ......................
234930 Cable, Work 50 Ft 6 Ga W/Clamp And Male Dinse 1................ .. ......................
213619 Clamp, Work 300 A Stl Chrome Pld W/Copper Contacts 1................ .. .................
213620 Contact Tip, Work Clamp 300amp Copper 2................ .. ..............................
234132 ICE−60T 20 Ft Hand Held Replacement Torch Or................ ..
234134 ICE−60T 50 Ft Hand Held Replacement Torch 1................ .. ..........................
234136 ICE−60TM 25 Ft Machine Replacement Torch 1................ .. ..........................
234138 ICE−60TM 50 Ft Machine Replacement Torch 1................ .. ..........................
To maintain the factory original performance of your equipment, use only Manufacturer’s Suggested
Replacement Parts. Model (located on nameplate on front of unit) and serial number (located on outside
bottom of plasma cutter base) is required when ordering parts from your local distributor.
234 843-B
234843-B
O-Ring
212735
(MachineCutting)
Gouging
Applysilicone
grease(169231)
beforeinstalling.
Electrode
212724
Tip
212725
Retaining
Cup
212733
Shield
212731
Shield
212732
SwirlRing
212734
Deflector
212736
DragShield
212730
DragShield
212730
Deflector
212736
Tip
219676
Tip
212729
Tip
219682
Tip
219680
60A
Retaining
Cup
212733
40A
Retaining
Cup
212733
60A
Retaining
Cup
212733
Retaining
Cup
212733
StandardCutting
ExtendedCutting
60A
40A
CupInstallation:Donotovertighten—finger-tightonly.
Turnoffpowerbefore
checkingtorchparts.
Checkbeforeeachuseand
hourlyduringoperation.
CAUTION
FAILURETOREPLACE
WORNTIPOR
ELECTRODEMAY
DAMAGETORCHAND
VOIDWARRANTY.
ICE-60T
CONSUMABLES
S
S
Figure 8-1. Consumable Parts For ICE-60T
To maintain the factory original performance of your equipment, use only Manufacturer’s Suggested
Replacement Parts. Model (located on nameplate on front of unit) and serial number (located on outside
bottom of plasma cutter base) is required when ordering parts from your local distributor.