Owner`s manual

. A complete Parts List is available at www.MillerWelds.com
OM-242 880 Page 41
7-4. Wrapper Removal/Installation
805 209-A
Tools Needed:
! Turn off power, and
disconnect input power plug
from receptacle or turn off
and lockout/tagout line dis-
connect device before
working on unit.
! Significant DC voltage can
remain on capacitors after
unit is Off. Check to see that
front panel lights (LEDs) have
stopped flashing and are off
before removing wrapper.
1 Wrapper
2 Front Bezel
3 Rear Bezel
4 Torx Screw (Fine Thread)
Remove 13 screws from wrapper,
and front and rear bezels as shown.
Spread open tops of front and rear
bezels.
5 Consumables Storage
Compartment Opening
Be sure that opening clears the
storage compartment. Lift wrapper
off unit.
. When installing wrapper, front
and rear wrapper flanges must
be on outside of front and rear
portion of metal chassis.
Torx 25
1
4
1
1
2
3
2
3
5