Owner`s manual
. A complete Parts List is available at www.MillerWelds.com
OM-242 880 Page 38
40 Amp Machine Torch Extended Consumables
The following cut charts are based on a distance of 1/16 in. (1.5 mm) between torch tip and workpiece for all cuts.
212 734212 724212 729212 733212 736
Swirl RingElectrodeTipRetaining CapDeflector
ICE-60TM Torch
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
125
0
26 ga 0.5 550 13970 353 8966
128 22 ga 0.8 484 12294 315 8001
128 18 ga 1.3 232 5893 151 3830
130 16 Ga 1.5 167 4242 109 2757
40 129 0.25 14 Ga 1.9 336 8534 218 5547
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
127
0
26 ga 0.5 561 14249 365 9271
127 22 ga 0.8 453 11506 295 7493
40
123
0.25
18 Ga 1.3 500 12700 325 8255
127 16 GA 1.5 365 9271 237 6026
128 14 GA 1.9 220 5588 143 3632
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
125
0
1/32 0.8 564 14326 366 9296
127 1/16 1.5 236 5994 153 3886
40 127 0.25 3/32 2.4 268 6807 174 4425
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.