Owner`s manual
. A complete Parts List is available at www.MillerWelds.com
OM-242 880 Page 37
40 Amp Machine Torch Shielded Consumables
The following cut charts are based on a distance of 1/16 in. (1.5 mm) between torch and workpiece for all cuts.
212 733212 732 212 734212 724212 725
Swirl RingElectrodeTipRetaining CapShield
ICE-60TM Torch
Sense Tab*
226 763
*Shield sense tab 226 763 provides feedback to a compatible torch height controller before starting the cutting process.
. Shield sense tab is located in the consumable storage box on left side of unit wrapper.
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
147
0
26 Ga 0.5 638 16205 415 10541
148 22 Ga 0.8 500 12700 325 8255
149 18 Ga 1.3 312 7925 203 5156
152 16 Ga 1.5 176 4470 114 2896
40
144 0.25 14 Ga 1.9 640 16256 221 5613
146 0.50 10 Ga 3.4 152 3861 99 2510
147 0.75 3/16 4.7 97 2464 63 1600
149 1.00 1/4 6.4 73 1854 47 1205
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
139
0
26 Ga 0.5 631 16027 410 10414
139 22 Ga 0.8 496 12598 322 8179
40
142
0.25
18 Ga 1.3 592 15037 335 8509
143 16 Ga 1.5 374 9500 243 6172
143 14 Ga 1.9 224 5690 146 3698
147 0.50 10 Ga 3.4 107 2718 70 1778
149 0.75 3/16 4.7 67 1702 44 1118
149 1.00 1/4 6.4 48 1219 31 792
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
25
150
0
1/32 0.8 610 15494 397 10084
151 1/16 1.5 188 4775 122 3104
40
146 0.25 3/32 2.4 293 7442 190 4826
149 0.50 1/8 3.2 276 7010 179 4557
150 1.00 1/4 6.4 78 1981 51 1288
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.