Owner`s manual

. A complete Parts List is available at www.MillerWelds.com
OM-242 880 Page 36
6-10. Cut Charts
60 Amp Machine Torch Shielded Consumables
The following cut charts are based on a distance of 1/16 in. (1.5 mm) between torch and workpiece for all cuts.
212 733212 732 212 734212 724219 676
Swirl RingElectrodeTipRetaining CapShield
ICE-60TM Torch
Sense Tab*
226 763
*Shield sense tab 226 763 provides feedback to a compatible torch height controller before starting the cutting process.
. Shield sense tab is located in the consumable storage box on left side of unit wrapper.
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
60
134
0
16 Ga 1.5 627 15926 502 12751
136 10 Ga 3.4 266 6756 213 5405
136 0.25 1/4 6.4 131 3327 85 2163
141 0.75 3/8 9.5 63 1600 41 1041
143 1.50 1/2 12.7 44 1118 29 726
147 5/8 15.9 31 787 20 508
153 3/4 19.0 22 559 14 356
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
60
134 0 16 Ga 1.5 625 15875 406 10312
136 0.25 10 Ga 3.4 244 6198 159 4039
139 0.50 1/4 6.4 112 2845 73 1849
145 0.75 3/8 9.5 53 1346 34 864
145 2.00 1/2 12.7 36 914 23 594
149 5/8 15.9 26 660 17 432
154 3/4 19.0 18 457 12 305
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Inches mm IPM mm/min IPM mm/min
60
135 0 1/16 1.6 666 16916 433 10998
138
0.25
1/8 3.2 400 10160 260 6604
139 1/4 6.4 147 3734 96 2427
146 0.75 3/8 9.5 74 1880 48 1219
147 1.50 1/2 12.7 51 1295 30 762
153 5/8 15.9 33 838 21 533
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.