Owner`s manual

. A complete Parts List is available at www.MillerWelds.com

OM-242 880 Page 21

4-15. Wiring Optional 240 Volt Plug (119 172) For Connection To Miller Bobcat,

Trailblazer Or Hobart Champion 10,000

Ref. 120 813-D / Ref. 805 161-A

Tools Needed:

3/16 in.

Check input voltage available at the

power supply.

. The Auto-LineE circuitry in this

unit automatically adapts the

power source to the 240 volts,

single-phase, 50 or 60 Hz

primary voltage from the power

supply.

1 Input And Grounding

Conductors

2 Plug Wired for 240 V, 2-Wire

Load

3 Neutral (Brass) Terminal And

Prong (Not Used)

4 Load 1 (Brass)Terminal And

Prong

5 Load 2 (Brass) Terminal And

Prong

6 Ground (Brass) Terminal And

Prong

7 Black And White Input Con-

ductors

8 Red Input Conductor

9 Insulation Sleeving

10 Electrical Tape

11 Green Or Green/Yellow

Ground Conductor

Insulate and isolate red conductor

as shown.

! Always connect green or

green/yellow wire to ground

terminal, never to a load

terminal. Connect black (L1)

and white (L2) wires to load

terminals.

Green Or

Green/Yellow

240V

Plug Front

View