Owner`s manual

OM-1593 Page 19
21. Troubleshooting For 25, 27, 40, 50, 55, 80, And 100 Ampere Torches
Trouble Remedy
Power source Cup trouble light On; no
cutting output.
Tighten cup onto torch and reset Power (see Section 15).
Check torch connections on power source. See power source Owner’s Manual.
Sparks come out top of cut, or cut is not
clean.
Torch travel speed too fast; reduce travel speed (see Section 13).
Clean or replace worn consumables as necessary (see Section 17).
Metal being cut is too thick; increase output control setting. See power source Owner’s Manual.
Be sure work clamp is securely attached. See power source Owner’s Manual.
Arc goes out while cutting. Make sure torch tip is contacting metal while cutting.
Be sure work clamp is securely attached. See power source Owner’s Manual.
Clean or replace worn consumables as necessary (see Section 17).
Arc goes on and off while cutting. Torch travel speed is too slow; increase travel speed (see Section 13).
Clean or replace worn consumables as necessary (see Section 17).
Be sure work clamp is securely attached. See power source Owner’s Manual.