Specifications

1
3
2
MILLER ELECTRIC MFG. CO., APPLETON, WI
MADE IN
4
7
5
6
Axcess
®
Control Panels
1. Power Switch
2. Handheld RS-232 Port
3. PC-Communication RS-232 Port
(Future use)
4. Network Feeder Connector
5. 115 VAC, 10 A Duplex Receptacle
6. Circuit Breakers
7. DeviceNet Connector (Optional)
1. Voltage/Arc Adjust Display Meter
2. Program Display
3. Program # Select
4. Process Setup Button
5. Control Knob
6. Trigger Receptacle
7. On/Off Button
8. Voltage Setup Button
9. Wire Speed Setup Button
10. Wire Speed/Amperage
Display Meter
11. Feeder Setup Button
12. Jog/Purge Switch
Front Panel
Rear Panel
Program
Process
Wire Type
Gas Type
Volts Time Arc Adjust
WFS Amps Arc Ctl
Process Set Up
Adjust
Feeder Set Up
Trigger Hold
Trigger Control
Sequence
5
4
7
6
3
2
1
8
9
11
12
10
7 in
(178 mm)
13 in
(330 mm)
Single Axcess
Feeder and
Remote Operator
Interface (ROI)
Capabilities
Dual Schedule— Toggle between two settings
using a single wire.
4T— When trigger is released, output will
operate at different ranges.
Trigger Program Select (TPS)— Provides the
ability to “Axcess” any of the Multi-MIG
®
processes or any of the eight active programs.
Trigger Dual Schedule (TDS)— When activated
allow selection between predetermined program
pairs (e.g. 1,2 – 3,4 – 5,6 – 7,8).
Trigger Hold (TH)— When activated, allows
gun trigger release and continuous welding until
trigger is pulled again.
Carbon Arc Gouging (CAC-A)—Can be activated.
Sequence
Preflow: 0.1–5 sec
Start Power: 0.1–5 sec
Crater: 0.1–5 sec
Postflow: 0.1–5 sec
Arc Adjust— Arc length (Trim)
Arc Control— Arc force or focus (SharpArc
®
)
Process Selection— Accu-Pulse
®
, Pulsed MIG,
MIG, Metal Core, RMD
™
(Optional)
4
Learn More at MillerWelds.com/AMS