Specifications
Standard Running Gear #042 886
The large 10 in (254 mm) rear wheels and
5 in (127 mm) front casters on this running
gear provide excellent mobility on the shop
floor, making it easier to move the power
source. Very easy to install. Handles double
as weld cable holder.
Standard Cylinder Rack #042 887
Holds two cylinders. Only installs on
Standard Running Gear.
Turntable Assembly #146 236
Allows rotation of the feeder as the operator
changes work positions. Reduces strain
and bending on the gun cable.
Wire Reel Assembly #108 008
For 60 lb (27 kg) coil of wire.
(Cannot use when handle is installed.)
Feeder Cart #043 698 Field
A low-profile creeper cart with high-quality
rubber casters, front swivel and rear rigid.
3
Genuine Miller Accessories
Genuine Miller Options
Digital Meter #186 498 Field
Dual-function, back-lit LCD digital meter
with selector switch. The digital meter
allows the wire feed speed to be preset in
meters per minute or inches per minute.
The voltage function will only monitor and
display the arc voltage. The voltage display
can also be calibrated if required.
Preflow/Postflow and Spot Control
#186 496 Field
Installs inside feeder under an easy access
hinged cover. Provides up to 5 seconds of
spot weld time and has adjustable timers
(0.25 to 5 sec.) for controlling gas flow
prior to arc initiation and after completion
of weld.
Drive Roll Kits
Select drive roll kits from chart below according to type and wire size being used. Kit includes (4) drive rolls and inlet guide.
*Accommodates 3/64 in (.045 and .047 mm) wires.
“V” knurled
for hard-shelled
cored wires
Wire size
.023/.025 in (0.6 mm)
.030 in (0.8 mm)
.035 in (0.9 mm)
.040 in (1.0 mm)
.045 in (1.1/1.2 mm)
.052 in (1.3/1.4 mm)
1/16 in (1.6 mm)
.068/.072 in (1.8 mm)
5/64 in (2.0 mm)
3/32 in (2.4 mm)
#087 132
#046 780
#046 781
#191 917
#046 782
#046 783
#046 784
—
—
#044 750
—
#046 785
#046 786
#046 787
—
#046 788
#046 789
—
—
#046 792
—
#046 793
#046 794
#046 795
#089 985
#046 796
#046 797
—
—
—
—
#083 319
#083 320
#046 800
—
#046 801
#046 802
“U” groove for
soft wire or
soft-shelled
cored wires
“V” groove
for hard wire
“U” cogged for extremely
soft wire or soft-shelled
cored wires (i.e., hard
facing types)
Nylon Wire Guides for Feeding Aluminum Wire
Wire Size
.047 in (1.2 mm)
1/16 in (1.6 mm)
3/32 in (2.4 mm)
Inlet Guide
#151 203
#151 205
#151 207
Intermediate Guide
#058 837
#058 853
#058 841
Note: “U” groove drive rolls
are recommended when
feeding aluminum wire.
Turntable
Assembly
Wire Reel Assembly
Carrying
Handle
Feeder Cart