Owner`s manual

OM-243 477 Page 27
6-3 Configuration Option Menu (Continued)
Revision Information
This option identifies the unit’s weld library
(INFO LIB) and firmware revision (INFO
REV).
Press the Setup Button while the unit is dis-
playing INFO LIB to identify the unit’s weld
library.
Press the Setup Button while the unit is dis-
playing INFO REV to identify the unit’s firm-
ware revision.
Pressing the Setup Button while the unit is
displaying INFO NO will move to the next
configuration option.
Exit Configuration Option Menu
Press the Setup Button while the unit is dis-
playing EXIT NO to return to the first config-
uration option. Press the Setup Button while
the unit is displaying EXIT YES to exit the
Configuration Option Menu.
. The Configuration Option Menu can be
exited at any time by turning the unit off.
Only if the unit is turned off after EXIT
NO is displayed will configuration op-
tion changes be saved.
INFO
NO
EXIT
NO
SECTION 7 − GTAW OPERATION
7-1. Typical Connection For GTAW Process
804 841-B
! Turn off power before mak-
ing connections.
1 Foot Control
2 Gas Out Connection
(Optional)
3 Positive (+) Weld Output
Terminal
4 Remote 14 Receptacle
Connect desired remote control to
Remote 14 receptacle if required.
5 Gas In Connection (Optional)
6 Gas Cylinder
7 Negative (−) Weld Output
Terminal
8 TIG Torch
9 Workpiece
4
7
5
3
2
1
8
6
9