User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
RK-5409-5 Reference Kit User’s Guide 3-29
Viewing MeshScape Statistics
Viewing MeshScape Statistics
The following procedure describes how to view the network statistics recorded by MeshScape
Network Monitor, which provides information on the packets received and transmitted by the
network nodes (see
Figure 3-30):
1. From MeshScape Network Monitor, select Window>Statistics. The Statistics window is
opened, displaying the following information:
– Sample Time: Current date and time.
– Start Time: Date/time statistics recording session began.
– Elapsed Time: Total recording time.
– Count Down: Seconds before next sample is taken and window is refreshed.
– RX Bytes: Total bytes received.
– RX Packets: Total packets received.
– End Node Packets: Packets received from end nodes.
– Mesh Node Packets: Packets received from mesh nodes.
– MeshGate Packets: Packets received from MeshGate.
– Notify Packets: Packets sent from MeshGate to MeshScape Network Monitor for
notification events.
– TX Bytes: Total bytes transmitted.
– TX Packets: Total packets transmitted.
2. (optional) Select Reset to clear the information currently displayed and begin a new
recording session.
Caution
Selecting Reset will remove all statistics collection history.