User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
RK-5409-5 Reference Kit User’s Guide v
CAUTION
Initialization of the product should be performed only by a qualified systems administrator.
Compliance Statements
FCC Compliance
FCC compliance for Millennial Net’s RK-5409-5 Reference Kit (916MHz, 5-3-1) consisting of the following
models/components:
• EN-5409 end node
• MN-5409 mesh node
• MG-5409 MeshGate gateway
Compliance Statement (Part 15.19)
The Millennial Net RK-5409-5 Reference Kit complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Unlicensed Modular Approval (for OEMs)
The URM-G-916 complies with the FCC's 47CFR Part 15 rules and regulations as well as Part 15 Unlicensed
Modular Approval as outlined in DA 00-1407. Compliance with the Modular Approval rules allows an OEM
to integrate the URM-G-916 into other products without further FCC certification of the intentional
radiator, but an OEM must still test their final product to comply with unintentional radiator requirements of
47CFCR Part 15.
Under the Modular Approval rules, an OEM must comply with the following when integrating the
URM-G-916 into an end product:
1. The OEM must ensure that FCC labeling requirements are met. This shall include a clearly visible label on
the exterior of the end product with the following nomenclature:
Contains FCC ID: R8N-URM-G-916
2. The OEM must only use the reverse-SMA antennas listed below when integrating the device into an end
product. These antennas have been tested and approved for use with the URM-G-916. Integrating the
module using any other antenna will require testing to ensure compliance with FCC rules and
regulations.
Mobile Mark ½ wave Antenna Part Number: PSKN3-925RS