User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
B-4 Millennial Net
Performing MeshScape Programmer
Operations
You may use MeshScape Programmer to:
• upgrade the firmware image on the target device
• unlock features on the target device
• re-program the device and group IDs on the target device
Upgrading Firmware on the Target Device
To upgrade the firmware on a MeshGate or mesh node using the MeshScape Programmer
application:
1. Connect the target device to your computer and launch the MeshScape Programmer
application as described in the previous section.
The MeshScape Programmer main window appears as shown in Figure B-2.
Figure B-2.The MeshScape Programmer main window