User Manual
Table Of Contents
- RK-5409-5 Reference Kit for 916 MHz MeshScape™ Systems
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (MN-5409 only)
- Configuring RS-485 Operation (MN-5409 only)
- Using Watch Function to Display Configuration Information
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Sample Application
- B: Performing Firmware Upgrades and Configuring Device IDs
- Glossary
- Index
RK-5409-5 Reference Kit User’s Guide B-1
B
Performing Firmware Upgrades
and Configuring Device IDs
The MeshScape Programmer application supplied with your RK-5409-5 Reference Kit enables
you to upgrade the firmware on your MeshGates and mesh nodes, and re-program the group
and device IDs on your MeshScape System. The supplied End Node Configurator enables you to
program the group and devices IDs, default sample interval, and statistics reporting rate on end
nodes. This chapter contains information on how to use the MeshScape Programmer and End
Node Configurator applications and includes:
• ’Getting Started with MeshScape Programmer’ on page B-2
• ’Performing MeshScape Programmer Operations’ on page B-4
• ’Getting Started with End Node Configurator’ on page B-8
• ’Performing End Node Configurator Operations’ on page B-10