User's Manual
Table Of Contents
- MeshScape™ RK-5424-5 Reference Kit for 2.4 GHz MeshScape Systems User's Guide
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Running the Demo Application
- B: Using MeshScape Programmer
- Glossary
- Index
RK-5424-5 Reference Kit User’s Guide 3-21
Configuring Serial and ADC Data Formats
Configuring Serial and ADC Data Formats
The following procedure describes how to configure the format of displayed serial and ADC
information (see
Figure 3-21):
1. From MeshScape Network Monitor, select Edit>Data format. The Edit Data Format
window is opened.
2. Configure the following network attributes:
– Serial data format: Select the desired format for displaying serial data
(ASCII/Hex/Decimal).
– ADC data format: Select the desired format for displaying ADC data
(Voltage/Raw
Data).
3. Select OK to save the settings and exit the Edit Network window.
Figure 3-21. Configuring serial and ADC data formats
Select Edit>Data Format
1
Select OK
3
Configure data format attributes
2