User's Manual
Table Of Contents
- MeshScape™ RK-5424-5 Reference Kit for 2.4 GHz MeshScape Systems User's Guide
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Running the Demo Application
- B: Using MeshScape Programmer
- Glossary
- Index
RK-5424-5 Reference Kit User’s Guide 3-7
Configuring a Node’s Operation
E Serial Data
Config
This panel is used to select a serial I/O operation for a device: Off, Digital
UART, RS-232 (not supported), or RS-485 (not supported). Selecting
serial operation disables digital I/O functionality because these
operations share the same pins.
For details, see the following:
• ’Configuring UART Operation’ on page 3-12
F Serial Data
Out
This panel, which is only used if the node is configured for serial
operation, is used to send serial data to the node.
For details, see the following:
• ’Configuring UART Operation’ on page 3-12
G Watch This option opens a new window that displays information relating to
the node’s various interfaces, including analog and digital I/O
configuration states and packets received/sent.
Use this window to observe when configured changes have actually
occurred on the device.
For details, see ’Using Watch Function to Display Configuration
Information’ on page 3-16
H Update Updates the selected device with any changes made to its configuration.
Updating a device will reset the “last message” count.
Table 3-8. Device window functions (continued)
Item Description Function