User's Manual
Table Of Contents
- MeshScape™ RK-5424-5 Reference Kit for 2.4 GHz MeshScape Systems User's Guide
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Running the Demo Application
- B: Using MeshScape Programmer
- Glossary
- Index
2-2 Millennial Net
Installing the MeshScape System
Installing the MeshScape Wireless Sensor
Network
This section of the user’s guide describes how to install the reference kit’s hardware and
software components. Installation should be performed in the following order:
1. MeshGate (see ’MeshGate Setup (MG-5424)’ on page 2-3)
2. Mesh Nodes (see ’Mesh Node Setup (MN-5424)’ on page 2-8)
3. End Nodes (see ’End Node Setup (EN-5424)’ on page 2-12)
4. MeshScape Network Monitor (see ’Installing Contents of Millennial Net’s RK-5424
CD-ROM’ on page 2-15)
Once the hardware is set up and the MeshScape Network Monitor software installed, launch
MeshScape Network Monitor to verify that all hardware is detected and displayed.