User's Manual
Table Of Contents
- MeshScape™ RK-5424-5 Reference Kit for 2.4 GHz MeshScape Systems User's Guide
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Running the Demo Application
- B: Using MeshScape Programmer
- Glossary
- Index
RK-5424-5 Reference Kit User’s Guide B-5
Getting Started with MeshScape Programmer
7. Run the MeshScape Programmer application as described in the next section.
8. Move switch SW1 on the terminal board to the Off position.
9. Remove the programmed node from the terminal board.
10. Repeat steps 1 to 8 until all nodes have been configured as desired.
Launching MeshScape Programmer Using Windows
To launch MeshScape Programmer, do one of the following:
– Double-click on the desktop’s MeshScape Programmer icon.
– From the Windows taskbar, select:
Start>All Programs>MeshScape>MeshScape Programmer.
MeshScape Programmer runs as described in the next section.