User's Manual
Table Of Contents
- MeshScape™ RK-5424-5 Reference Kit for 2.4 GHz MeshScape Systems User's Guide
- Contents
- About This Guide
- 1: Introduction
- 2: Installing the MeshScape System
- 3: Running MeshScape Network Monitor
- MeshScape Network Monitor Overview
- Configuring a Node’s Operation
- Labeling an End Node or Mesh Node
- Configuring Persistence Attributes
- Selecting a Com Port on the Host PC
- Configuring Serial and ADC Data Formats
- Turning Event Tracking On/Off
- Broadcasting Data to All Nodes.
- Creating an Event Log File
- Viewing the Contents of an Event Log File
- Viewing MeshScape Statistics
- 4: Using the MeshScape API
- A: Running the Demo Application
- B: Using MeshScape Programmer
- Glossary
- Index
RK-5424-5 Reference Kit User’s Guide B-3
Getting Started with MeshScape Programmer
Figure B-1.Connecting MeshGate programming cable to a mesh node
Connecting an End Node for Programming
1. Connect a MeshGate to your computer as described on page B-2.
2. Remove the connector panel access cover from the MeshGate connected to the
computer.
3. Referring to Figure B-2 and using the supplied MeshGate programming cable and
MeshGate-to-end node adapter, connect the external programming port on the
MeshGate to port P8 on the end node terminal board.
Ensure that Pin 1 on the MeshGate-to-end node adapter mates with Pin1 on connector
P8 when making this connection.
4. Replace the MeshGate connector panel access cover, and disconnect the programming
cable after the firmware update is complete.
Figure B-2.Connecting MeshGate programming cable to an end node
External Programming Port
on MeshGate
External Programming Port
on Mesh Node
External Programming Port
on MeshGate Port P8 on the End Node
Terminal Board
End Node