User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
2-2 EK-5209-5 Evaluation Kit User’s Guide
Kit Installation
Installing the i-Bean Wireless Network
This section of the user’s guide describes how to install the evaluation kit’s hardware and
software components, which are installed in the following order:
1. i-Bean Gateway (see ’i-Bean Gateway Setup (GW-5209)’ on page 2-3)
2. i-Bean Routers (see ’i-Bean Router Setup (RT-5209)’ on page 2-6)
3. i-Bean Endpoints (see ’i-Bean Endpoint Setup (iB-5209)’ on page 2-9)
4. iB-5209 Network Monitor (see ’Installing contents of Millennial Net’s iB-5209 CD-ROM’
on page 2-10)
5. Applications Programming Interface (see API Functions (page A-1))
Once the hardware is set up and the software (iB-5209 Network Monitor) installed, you will
launch iB-5209 Network Monitor and verify that all hardware is detected and displayed by
iB-5209 Network Monitor.