User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
B-6 EK-5209-5 Evaluation Kit User’s Guide
TempMonitor Overview
The TempMonitor application displays temperature changes vs. time for one device only. Use
the Device Selection area to select the endpoint with matching device ID, then click Update
button to configure the device (enable ADC channel 1). The Run/Stop button is used to control
the display curve updating; Run means continuously update the curve, Stop means to freeze
the current curve. The precise reading can also be obtains from the Realtime Sensor Reading(F)
area.
Figure B-5. TempMonitor display
You can change the environment temperature to observe changes to the graph’s curve.