User's Manual

vi Millennial Net
Unlicensed Modular Approval (for OEMs)
The URM-G-2400 and URM-M-2400 comply with the FCC's 47CFR Part 15 rules and regulations as well as
Part 15 Unlicensed Modular Approval as outlined in DA 00-1407. Compliance with the Modular Approval
rules allows an OEM to integrate the URM-G-2400 and URM-M-2400 into other products without further
FCC certification of the intentional radiator, but an OEM must still test their final product to comply with
unintentional radiator requirements of 47CFCR Part 15.
Under the Modular Approval rules, an OEM must comply with the following when integrating the
URM-G-2400 and URM-M-2400 into an end product:
1. The OEM must ensure that FCC labeling requirements are met. This shall include a clearly visible label on
the exterior of the end product with the following nomenclature:
Contains FCC ID: R8N-MG5424XL
2. The OEM must only use the reverse polarity-SMA (RP-SMA) antennas listed below when integrating the
device into an end product. These antennas have been tested and approved for use with the
URM-G-2400 and URM-M-2400. Integrating the module using any other antenna will require testing to
ensure compliance with FCC rules and regulations.
Centurion ½ wave Antenna Part Number: WCR2400SMRP
3. The OEM must use the same cable type and of the same length or longer than that defined below. Use
of another cable type or of a shorter length will require testing to ensure compliance with FCC rules and
regulations.
RF Cable type: RG174
RF Cable Length: 5.9" +/- 0.13”
Millennial Net Cable P/N: CBL-0018-01
Industry Canada Compliance Statement
This device has been designed to operate with an antenna having a maximum gain of 2.65 dB. Antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 Ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
OEM Integration
The modules have the same requirements for integration into an OEM product for Industry Canada as it
does for FCC. The only difference being the labeling nomenclature required on the exterior of the OEM
product. The following must be clearly visible on the exterior of the OEM product:
Contains IC: 5172A-MG5424XL