User's Manual

2-2 Millennial Net
Installing the MeshScape System
Installing the MeshScape Wireless Mesh
Network
This section of the user’s guide describes how to install the reference kit’s hardware and
software components. Installation should be performed in the following order:
1. MeshGate Extra Long Range (see ’MeshGate Extra Long Range Setup (MG-5424XL)’ on
page 2-3)
2. Mesh Nodes (see ’Mesh Node Setup (MN-5424)’ on page 2-12)
3. End Nodes (see ’End Node Setup (EN-5424)’ on page 2-16)
4. MeshScape Network Monitor (see ’Installing Contents of Millennial Net’s RK-5424
CD-ROM’ on page 2-19)
Once the hardware is set up and the MeshScape Network Monitor software installed, launch
MeshScape Network Monitor to verify that all hardware is detected and displayed.