User Manual
Table Of Contents
- About This Guide
- Introduction
- Kit Installation
- iB-5209 Network Monitor Operations
- iB-5209 Network Monitor Overview
- Setting Thread Priority
- Configuring a Node’s Operation
- Using Watch function to display current I/O information
- Configuring Sample Interval of Single Node
- Configuring Sample Interval of all Network Nodes
- Configuring Digital I/O Operation
- Configuring UART Operation
- Configuring AD (analog-to-digital) Converter Operation
- Configuring RS-232 Operation (RT-5209 only)
- Configuring RS-485 Operation (RT-5209 only)
- Labeling i-Bean Endpoint or i-Bean Router
- Creating an Event Log File
- Configure Persistence Attributes
- Configure Serial and ADC Data Formats
- Select Com Port on Host PC
- View Monitor Statistics
- View Contents of Event Log File
- Enable Multiple Capture
- API Functions
- Sample Application
3-24 EK-5209-5 Evaluation Kit User’s Guide
iB-5209 Network Monitor Operations
Select Com Port on Host PC
The following procedure describes how to select the RS-232 com port for iB-5209 Network
Monitor to use to communicate with the i-Bean Gateway (see Figure 3-15):
1. From iB-5209 Network Monitor, select Edit>Com Port. The Edit COM Port window
displays.
2. Select the RS-232 com port to use from the drop down list of available ports, then select
OK. iB-5209 Network Monitor will communicate with the i-Bean Gateway connected to
the selected port.
Figure 3-15. Selecting com port on host PC
Select Edit>Com Port
1
Select port to use,
2
then select OK