Getting Started

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 490348_25.03.2021
For the packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly dis-
posed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings
on the packaging.
Safety instructions
Intended use
This device is used as a wall mount for devices with VESA bracket. Any other use
or use under other operating conditions is considered to be improper and may
result in personal injury or property damage. No liability will be assumed for da-
mages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and
are not within reach of babies and young children. Choking hazard!
Ensure that children do not detach any small parts from the product.
They could swallow the pieces and choke! Never let children unatten-
ded use electrical devices.
VESA Stand Wall MKII
Quick Start Guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include this
quick start guide.
General handling
Do not immerse the unit in water. Wipe only with a clean and dry cloth. Do not use
liquid cleaners such as benzene, thinners or ammable cleaning agents.
Keep the device away from impurities!
Keep the device away containers with liquid. Should liquid fall into the unit, this could
lead to its destruction or re. Be aware that no metallic parts come inside the device.
Suitable mounting hardware
Use mounting hardware which is suitable for the intended wall or mounting surface
for mounting the bracket.
Mounting
1. Mount the bracket using the mounting hardware suitable for the type of
wall.
2. Choose the appropriate screw set (D or E) and x the back of the monitor to
the support plate with a washer (A or B) for each screw. If necessary, mount
the spacers (C) between support plate and monitor.
A
B
D
E
C
3. To adjust the desired angle towards the wall (± 20 ° horizontal or
± 45 ° vertical), loosen the nut (size 14) using a suitable wrench, adjust the
angle and then re-tighten the nut.
Technical specications
Hole spacing: 75 mm×75 mm or
100 mm×100 mm (VESA)
Maximum load capacity: 15kg
Inclination angle: ± 20 ° horizontal, ± 45 ° vertical
admissible monitor size: 10 ... 26"
Wall spacing: 75 mm
EN
Scope of delivery
Washers Ø 4 (A, 4 pcs)
Screws M4 × 15 (D, 4 pcs)
Spacers 5 mm (C, 4 pcs)
Screws M5 × 15 (E, 4 pcs)
Wall plate Support plate
pre-assembled
Wall
Monitor
Washers Ø 5 (B, 4 pcs)