Data Sheet

DocID: 235772_20.06.16
Thomann GmbH
Hans-Thomann-Straße 1 • 96138 Burgebrach
Germany • www.thomann.de
EN
PHP 2 Phono preamp
This device is intended to amplify the RIAA signal from a turntable to hi- level.
Any other use or use under other operating conditions is considered to be
improper and may result in personal injury or property damage. No liability will
be assumed for damages resulting from improper use.
Ensure that plastic bags, packaging, etc. are properly disposed of and
are not in the reach of babies and young children. Choking hazard!
Ensure that children do not detach any small parts from the product.
They could swallow the pieces and choke! Never let children use electrical
devices unattended.
The plasticiser contained in the rubber feet of this product may possibly react
with the coating of your parquet, linoleum, laminate or PVC oor and after
some time cause permanent dark stains. In case of doubt, do not put the
rubber feet directly on the oor, but use felt-pad oor protectors or a carpet.
This product is subject to the European Waste Electrical and Electronic
Equipment Directive (WEEE) in its currently valid version. Do not dispose
of your old device with your normal household waste. Dispose of this
product through an approved waste disposal rm or through your local
waste facility. Comply with the rules and regulations that apply in your country. If
in doubt, consult your local waste disposal facility.
For the transport and protective packaging, environmentally friendly
materials have been chosen that can be supplied to normal recycling.
Ensure that plastic bags, packaging, etc. are properly disposed of. Do not
just dispose of these materials with your normal household waste, but make sure
that they are collected for recycling. Please follow the notes and markings on the
packaging.
Features
 Stereo RCA input sockets to connect a turntable
 Ground pin for connection to the turntable
 Stereo RCA output sockets to connect an amplier
 1/4“ TRS output to connect an amplier
 1 × LED for power indicator
 Power adapter included
Technical specications
 Operating voltage: 12V via supplied mains adapter
(centre pin = negative pole)
 Dimensions: 95mm×73 mm×40mm
 Weight: 289g