User manual

5.11.5 Information about the USB ash drive (USB stick)
1. Press [SETUP] and [OK] simultaneously to enter the USB menu.
ð
The display shows the respective submenus.
2.
Press or to select the menu item ‘INFO’ .
ð
The display shows the respective submenus.
3. Press [SELECT] repeatedly to switch between submenus.
1 Shows the total storage capacity of the USB ash drive.
2 Shows the remaining storage capacity of the USB ash drive.
3 Formats the USB ash drive.
Conrm the selection with [OK].
Press [SELECT] repeatedly to choose between ‘No’ (cancel formatting)
and ‘Yes’ (formatting) and conrm your selection with [OK].
4 Defrags the USB ash drive.
Conrm the selection with [OK].
Press [SELECT] repeatedly to choose between ‘No’ (cancel defrag) and
‘Yes’ (defrag) and conrm your selection with [OK].
Do not switch o the device during the defrag.
4. After the formatting / defrag, the device restarts and the display shows
‘welcome’ .
ð
The device is operational again.
Formatting erases all les on the USB ash drive (USB stick). Make sure there
are no les on the USB ash drive (USB stick) that you want to keep.
5.12 Device version
1. Press [SETUP] to enter the settings menu.
ð
The display shows the respective submenus.
2.
Press or to select the menu item ‘VER’ .
ð
The display shows the versions of the software operating the device.
3.
1 Shows the version of the internal sounds.
2 Shows the rmware version.
3 Shows the synthesizer version.
4 Shows the version of the detection algorithm.
ö
#
$
%
#
ö
$
%
Operating
30
NonaPad
Sampling Percussion Pad