User manual

Table Of Contents

5.4.1 Sound displays structure

1 Shows the currently selected pad.

2 Shows the sample level of layer mode.

In layer mode, the pads can be assigned in such a way that, depending on the

intensity of the strike, dierent sounds in dierent volumes with dierent

eects are generated on the same pad.

Hit the pad to select sample ‘A’ or sample ‘B’ for editing. Please note that it is

not possible to select sample ‘B’ , when ‘Type’ is set to ‘OFF’ , and set the ‘Layer

point’ respectively.

3 Shows the name of the currently selected sound to which the currently edited

pad is linked.

Use the rotary control or press [–/+] to change the sound. Conrm the selec‐

tion with [OK].

4 Shows the volume of the selected sound.

Use the rotary control or press [–/+] to change the overall volume of the sound

between ‘0’ and ‘127’ . Conrm the selection with [OK].

5 Shows the setting of the layer mode.

If the pad is set to have both sample ‘A’ and sample ‘B’ , any time you hit the

pad that is louder than the set threshold ( ‘0’ … ‘127’ ), sample ‘B’ will be

played. If, for example, the threshold is set to ‘50’ , sample ‘A’ will be played

when you hit the pad quieter than ‘50’ , sample ‘B’ when you hit the pad

louder than ‘50’ .

Use the rotary control or press [–/+] to change the threshold for switching

from sample ‘A’ to sample ‘B’ from ‘0’ to ‘127’ . Conrm the selection with

[OK].

6 Shows the functioning of the layer mode.

‘OFF’ : only sample A is played.

‘MIX’ : when the set threshold value for the layer mode is reached, sample ‘B’ is

overlaid with sample ‘A’ .

‘SWITCH’ : when the set threshold value for the layer mode is reached, sample

‘B’ will replace sample ‘A’ .

‘FADE’ : when the set threshold value for the layer mode is reached, sample ‘B’

is played in the same way as sample ‘A’ .

Use the rotary control or press [–/+] to change the functioning of the layer

mode. Conrm the selection with [OK].

ö #

Operating

NonaPad

Sampling Percussion Pad