User manual: FW V1.1.5

Samples stored on the USB stick can be loaded into the drum module and saved
there as a user voice. The user voices can be used in the same way as the supplied
voices. Maximum sample size is 15 MB. It must be stored as a WAV le (mono) with a
resolution of 16 bit and a sampling rate of maximum 48 kHz.
1. Press [KIT].
ð
The display shows the kit list.
2.
Press [MENU]. Use the arrow buttons ( / ) to select the option ‘USB’ and press
[ENTER].
ð
The display shows the ‘USB MEMORY’ menu.
3.
Use the arrow buttons ( / ) to select the option ‘SAMPLE LOAD’ . Conrm with
[ENTER].
ð
The display shows the list of WAV les detected on the USB stick.
4.
Use the arrow buttons ( / ) to select a le. Conrm with [ENTER].
ð
The display shows ‘Load to User Voice’ .
5. Conrm with [ENTER].
ð
The sample is being loaded. This can take about a minute, depending on
the le size.
The settings you have made for a kit can be saved on the USB stick and used again
later.
1. Press [KIT].
ð
The display shows the kit list.
2.
Press [MENU]. Use the arrow buttons ( / ) to select the option ‘USB’ and press
[ENTER].
ð
The display shows the ‘USB MEMORY’ menu.
3.
Use the arrow buttons ( / ) to select the option ‘KIT SAVE’ . Conrm with
[ENTER].
ð
The display shows the list of the kits (01…99). If there is no name next to a
kit number, then no kit has yet been saved for this number.
4.
Use the arrow buttons ( / ) to select a kit. Conrm with [ENTER] or press [EXIT]
to exit the menu.
ð
The kit is being saved.
Loading a sample from the USB stick
and saving it as a user voice
Storing kit settings on the USB stick
Operating
24
MPS-850
E-Drum Module