User manual: FW V4.14

The preprogrammed sounds of the drum module can be programmed to any of the connected

pads. So you can create user kits and store them in the device. To do so proceed as follows:

1. First, call up one of the available drum kits (see previous chapter) and use [EDIT] to

switch to Edit mode.

2. Hit the pad (Trigger) to which you want to programme a certain sound or press [DRUM]

repeatedly until the desired pad is shown on the display. Additionally select the specic

trigger for multiple assigned pads.

3. Use [PAGE DOWN] or [PAGE UP] to successively open the following selection menus and

use the rotary control [–] / [+] or the buttons [–] | [+] to adjust the settings for the acti‐

vated trigger.

Selection menu Value range

VOICE TYPE Kick, Snare, Tom, Ride, Crash, Hi-Hat, Metro, Extras

VOICE Voice selection, see

VOLUME Volume

REVERB Reverb eect

PITCH Pitch

PAN Position within the stereo signal (panorama right / left)

4. Quit the selection menu with [EXIT].

Use [–] | [+] in the following saving dialogue to specify the memory location. Existing

data will be overwritten.

Customising a drum kit

Operating

MPS-750X

E-Drum Module